Resources for Hands-On Training
Checklists, lesson plans and setup guides we use on the shop floor, gathered in one place for trainers, supervisors and new hires.
The Training Sequence We Follow
Every course runs in the same order. Use these steps to plan your own sessions or to check that a course you are reviewing has all of them.
Map the task
Write down each action the trainee must perform, in the order it happens on the job. Note the tools, materials and the point where most errors occur.
Demonstrate once
Perform the task slowly while the trainee watches. Name each safety check out loud so the reasons stay with them after the session.
Practise under supervision
The trainee repeats the task while the trainer stays beside them. Correct posture, grip and measurement before speed is allowed.
Sign off on the floor
Record the result on the competency sheet only after three clean repetitions. Any failed check returns the trainee to Step 03.

Set Up the Bench Before the Session
A clear bench keeps attention on the task. Lay out only the tools for the current lesson, mark the reach zone for each trainee and check guards before the first demonstration.
See our coursesBefore You Run Any Session
- Confirm the trainee holds current PPE sizes and fits them before work starts.
- Print the task map and leave one copy at the station for reference.
- Check that every machine has a visible isolation point and a working stop.
- Agree on a single sign-off signal so the trainee knows when to pause.
- Log the session date, tasks covered and the name of the supervising trainer.

Lesson Plans You Can Adapt
Each plan lists the objective, the materials, the timing and the check questions. Change the order to suit your floor, but keep the safety checks where they are.
Request the full plan setField Photos
Real stations from client sites, shown as the trainee sees them on day one.

